Rapid-air SMART MINI-SERVO FEED CUT-TO-LENGTH: SMS2, SMS4, S Bedienungsanleitung Seite 1

1RAPID-AIR CORPORATION4601 KISHWAUKEE ST. • ROCKFORD, IL 61109-2925Phone: (815) 397-2578 • Fax: (815) 398-3887 • Web Site: www.rapidair.comsmart min

10RSC14/SMS2 Servo Control Assembly

11Operator Interface Terminal Programming ProcedureThis section is to familiarize an opera-tor with the terminal screen (program) flow. Also, the sect

12Programming Procedure (continued)A VALID JOB # MUSTBE ACTIVE TO GO ONGO TO JOB ENTER SCRN JOB SCRN F6=EXITSECTION 2 F2 - MANUAL MODEPressing F2

13Programming Procedure (continued) EXIT SET COUNTER VALUES SET RESET BATCH/ TOTALF1, set batch, on the “SET COUNTER

140.1.2.3.4.5.6.7 (not flashing)7.89Ab.cE.F.IHh or h.IJJ. oº.P. (.flashing)P. (.steady)r•S--.=S1•troubleshootingDisplay DescriptionInternal communic

15There are two CAN LEDs , the left LED shows activity on the CAN1 (CANopen) bus. The right LED shows activity on the CAN2 (Baldor CAN) bus. Each LED

16led status symbolsSymbol DescriptionDrive / comms watchdog. Internal communications failure. Clear the error; if the problem persists then conta

17led status symbols (continued)Symbol DescriptionPower base not ready. This error condition applies only to 3-phase models. These drives have a p

18led status symbols (continued)Symbol DescriptionPreset trapezoidal move active (in motion).DB Overload. The regeneration resistor (Dynamic Brake

19SMS - CTL Feed

2INTRODUCTION, INSTALLATION AND SET-UP ... pg. 3ADJUSTMENT, CABLING

20SMS - CTL Servo Feed

21SMS with Cutter Control Panel Assembly

22SMS with Cutter Wiring Schematic

23ALL SALES BY THE COMPANY ARE MADE SUBJECT TO THE FOLLOWING TERMS AND CONDITIONS. PLEASE READ.WARRANTY – The Company warrants, for a period of one

3The Rapid-Air Servo Cut-To-Length Feed system carries with it the quality and reliability you have grown to expect from a Rapid-Air product. The mot

4Every servo feed has an eccentric adjustment screw to adjust the upper roller to be in parallel to the lower roller. The maximum adjustment is .008”

5Now that your servo/cutter combina-tion is in place, and the cables have been attached, you can proceed with testing the unit. The first step is to t

6No power indicationNo display on operators consolePower on – no motionMaterial will not enter rollsMaterial will not feedMaterial feeds shortMateria

7Problem Cause Remedytroubleshooting (continued)Material feeds off ce

8CUTTER DATA: See specific cutter specifications.OPERATIONS: The solenoid valve, which is remote mounted, is attached to the cutter (item #3) by a plas

9FSC8/SMS8 Control Assembly