Rapid-air MULTI-STROKE CONTROL Bedienungsanleitung PDF herunterladen (Seite 8)

ISOLATED NORMALLY OPEN CONTACT PROVIDED

TO CUSTOMER. THE CONTACT WILL CLOSE WHEN

THE PRESET COUNT OF THE MULTI-STROKE UNIT

HAS BEEN REACHED (MAX 120 VAC).

NORMALLY CLOSED LIMIT SWITCH (SUPPLIED

BY CUSTOMER) TO BE MOMENTARILY OPENED

AFTER WORK CYCLE OF THE EXTERNAL

EQUIPMENT TO PROVIDE A RESET SIGNAL.

NOTE-1: IF THE RESET SWITCH IS ALLOWED TO

BE HELD OPEN THEN AN UNCONTROLLED START

CYCLE COULD BE INITIATED.

NOTE-2: THE MULTI-STROKE UNIT CYCLE IS

CONTROLLED BY THE PRESS CYCLE. TURNING

OFF THE MULTI-STROKE UNIT BEFORE THE

PRESS CYCLE IS COMPLETE COULD ALLOW THE

PRESS TO CONTINUE CYCLING.

SEQUENCE OF OPERATION

1. SUPPLY 120 VAC TO MULTI-STROKE UNIT THROUGH POWER CORD PROVIDED.

2. PUSH GREEN “ON” PORTION OF POWER PUSHBUTTON.

3. TURN “STOP-START” SELECTOR SWITCH TO THE “START” POSITION, AND RELEASE IT. IT WILL SPRING

RETURN TO THE RUN POSITION.

4. THE FEED WILL BEGIN TO CYCLE FOR THE NUMBER OF STROKES SET ON THE “FEED STROKES PER

CYCLE” ROTARY SWITCH.

5. THE FEED WILL CYCLE AT THE RATE DETERMINED BY THE SETTING ON THE “FEED RATE” POT. (THE

FEED RATE CAN BE DOUBLED THROUGH A TOGGLE SWITCH LOCATED ON THE PRINTED

CIRCUIT BOARD.)

CAUTION: TOO FAST OF A SETTING WILL CAUSE IMPROPER

FEED ACTUATION. MISFEEDING WILL RESULT.

6. AFTER THE FEED HAS OPERATED FOR THE PRESET NUMBER OF STROKES THE FEED WILL STOP

AND THE MULTISTROKE WILL ACTUATE THE SOLID STATE RELAY, PROVIDING THE CUSTOMER WITH AN

ISOLATED CONTACT OUTPUT FOR USE IN HIS EXTERNAL CONTROLS.

7. AFTER THE WORK CYCLE OF THE EXTERNAL EQUIPMENT, A NORMALLY CLOSED LIMIT SWITCH (OR

CONTACT) MUST BE OPENED MOMENTARILY TO PROVIDE A RESET SIGNAL TO THE

MULTISTROKE CONTROL.

8. TURNING THE “START - STOP - RUN” SELECTOR SWITCH TO THE STOP POSITION WILL ALLOW THE

PRESENT FEED STROKE CYCLES TO COMPLETE THE PRESET NUMBER OF STROKES HOWEVER, A

RESET SIGNAL WILL NOT ACTUATE ANOTHER MULTISTROKE PROGRESSION CYCLE.

9. SLIDING THE INITIATE SWITCH TO THE “A” POSITION ALLOWS THE MULTI-STROKE CONTROL TO BE

ACTUATED BY THE EXTERNAL RESET SIGNAL ONLY. IF THE SLIDE SWITCH IS IN THE “B” POSITION THE

SEQUENCE CAN BE INITIATED BY EITHER THE CONSOLE PUSHBUTTON OR THE EXTERNAL RESET SIGNAL.

1 2 3 4 5 6 7 8 9 10

Keine Kommentare

Rapid-air MULTI-STROKE CONTROL Bedienungsanleitung Seite 8